Brocock Bantam Pressure Regulator

Brocock Bantam Pressure Regulator

Out of stock

€ 134.95

Brocock Bantam Tuning Regulator

This External PCP Regulator build by Huma-Air is specialy designed for several air rifles with a pressure bottle with M18x1,5 treads like the Brocock Bantam
The regulator will reduce the outgoing pressure of your rifle's pressure bottle according to your settings and this will result in a constant pelletspeed and better groups.
It is equipped with a pressure gauge what will indicate the fill pressure of the bottle and a foster male connection to fill the rifle. The position of the gauge and and foster can be chosen left or right and they can be aligned stepless into their position so it always looks good on your rifle.

When the regulator is fitted to the rifle you can read the regulator output pressure on your rifles's pressure gauge and the fill pressure will be shown on the regulator gauge.
Pressure can be set by turning the set-screw of the regulator. A 5 minutes turn contra clockwise equals to about 6-7 bar pressure increase.
(your original rifle's fill connection cannot be used anymore as it is replaced by the regulator foster male fill connection)
The benefits of this Huma-Air tuning regulator for your Brocock Bantam 

  • Higher accuracy of your Brocock Bantam due to the elimination of the pelletspeed fluctuations
  • The solid stainless steel foster fill connection and pressure gauge can switched over from left to right
  • The position of the foster and pressure gauge can be turned around for 360 degrees. So you aligned it to your own wishes.
  • Under the pressure gauge there is a o-ring what make it posible to line the dialplate up straight for the eye. 
  • It will give you a constant pellet speed over the full working pressure range.
  • It will give you a better shotcount and a full flat shotstring immediately.
  • Adding a regulator to your airrifle will probably give you the biggest benefit in the tuning process.
  • Often the rifle will make less noise due to better balance in air usage.
Pressure settings of the Huma-Air bottle regulator
Your bottle regulator comes preset on the pressure we have tesed it and it is marked on the packing. You can set the regulator according to your wishes within the pressure range of 70-155 bar output pressure
The output pressure will be shown on the factory pressure gauge of your airrifle.
The Bantam has a limited amount of regulated air inside the action. We tested the Bantam to maximum of about 25 ft/lbs with 16 gn JSB in .22 for around 50 shots and 70 shots in 23 ft/lbs.

These regulators can only be used on the original rifle's pressure bottle. Do not exceed the factory adviced fill pressure or exchange the orginal factory botlle for a higher pressure version.
These regulators are not suitable for a CO2 to HPA conversion, because they no have a burst disk.
Huma-Air Quality Control
Huma-Air regulators are CNC produced out of high grade aircraft Aluminum and bronze.
To guarantee a perfect product, every regulator is manually assembled, tested and adjusted to the requested pressure. 
We only use high-end materials and our belleville springs are designed for critical applications to achieve the highest repeat accuracy. This gives our regulators a repeat cycle less than 1% difference.